GRAPHTEC CS2000 User Manual page 42

4. LOADING A DOCUMENT
4.2 Loading a Document
For standard-size documents
Insert the document into the document-scanning table with the face to be scanned facing
downward, so that it is aligned with the center section, to ensure that it is not scanned
at an angle. The two modes described below are provided for loading the document (set
from the driver software).
The rollers start rotating after a preset delay time after the document is inserted, to
automatically advance the document to the initial position for scanning.
The rollers start rotating when the FORWARD switch is pressed on the control panel after
the document is inserted, to automatically advance the document to the initial position
for scanning (manual loading).
To reposition the document, press the REVERSE switch to remove it, and load it again.
Scanning table
The PAPER LED lights when a document has been loaded in the scanner.
If the PAPER LED does not light after the document feed operation has stopped, press
the FORWARD key to advance the document again.
4 – 2 CS2000