Table of Contents
Advertisement
(2) If the SCSI cable comes into contact with the document, use the cable clamp provided
as a standard accessory to fasten the cable to the underside of the scanner, at either
the left or right side.
(3) Insert the cable's other end into the computer's connector.
(4) If this scanner will be a terminal within the network configuration, set Bit 4 of the DIP
switch on the scanner's rear panel to enable the internal terminator function.
• The scanner comes with the Terminator setting of "Enable" as its factory-preset
default.
• Turn off the scanner before changing a DIP switch setting.
CS2000
Cable clamp
SCSI cable
ON
4
3
2
1
Terminator
3. PREPARING TO OPERATE THE SCANNER
DIP switch's bits
4
3
2
ON
Disable
OFF
Enable
Usually OFF
1
3 – 5
Advertisement
Table of Contents
