Replace A Die Set - Oce VarioPrint 6000 User Manual Operating Information

Replace a die set

Introduction
The puncher can use many different die sets to punch your documents (see
available' on page
Please contact your puncher supplier for additional or replacement die sets.
This section describes how to remove and install a die set.
Note:
Only replace a die set when the printer is on hold.
Illustration
[116] Replace a die set
Remove and install a die set
Open the front door of the puncher.
1.
Grasp the finger hole of the die set and pull firmly. Slide the die set out of the slot. Make
2.
sure that you support the die set with both hands.
If possible, place the removed die set into the storage area inside the puncher cabinet.
3.
185). The die set determines the punching pattern.
Chapter 6 - Optional finishers and other devices
Replace a die set
'Die sets
189