#
Toner pollution problem
Toner pollution on the first
sheets after the automatic black
image cleaning procedure.
Toner pollution on the first
sheets along the edge of the sheet
(2-3 mm) after the automatic
black image cleaning procedure.
Solution
•
Change the 'Paper quality' setting from 'Nor-
mal' to 'Low' (see
on page
133).
•
Use the 'Paper quality test' to determine if this
new setting is the right cleaning mode for this
media.
•
The sheets of the 5
free, also at the edges of the media size width.
•
When these sheets still show toner pollution,
you can set the 'Paper quality' setting to 'Lower'
(see
'Change the Paper quality ' on page
•
Use the 'Paper quality test' to verify that this
new setting is the right cleaning mode for this
media.
•
Change the 'Paper quality' setting from 'Nor-
mal' to 'Low' (see
on page
133).
•
Use the 'Paper quality test' to determine if this
new setting is the right cleaning mode for this
media.
•
The sheets of the 5
free, also at the edges of the media size width.
•
When these sheets still show toner pollution,
you can set the 'Paper quality' setting to 'Lower'
(see
'Change the Paper quality ' on page
•
Use the 'Paper quality test' to verify that this
new setting is the right cleaning mode for this
media.
Note:
When the peripheral pollution mainly
occurs at 1 side of the sheet, it is advised
to rotate the media in the paper tray by
180 degrees.
Chapter 7 - Keeping the printer running
Troubleshooting
'Change the Paper quality '
th
set must be totally toner
'Change the Paper quality '
th
set must be totally toner
133).
133).
249