Oce VarioPrint 6000 User Manual Operating Information page 214

Adjust the folding skew
Adjust the folding skew
Introduction
By default, the puncher/folder is set to Z-fold. If you switch to half-fold, it is possible for
your sheets to show a folding skew. You can correct this folding skew using the knob
underneath the left-hand top cover of the puncher/folder. If you switch back to Z-fold,
you can turn the knob until you have reached the default position. You can find this default
position on the sticker inside the puncher/folder.
Folding skew correction
The following table gives an overview of the relation between the number of complete
rotations of the knob and the amount corrected in millimeters.
Folding skew correction
[138] A folding skew
214 Chapter 6 - Optional finishers and other devices
#
Folding skew error (mm)
0.5
1.0
1.5
2.0
2.5
3.0
Correction (in rotations)
1.5
3
4.5
6
7.5
9