Clear a paper jam
Open the front door of the puncher.
1.
Check if the chip tray is not too full.
2.
Follow the steps in the table.
3.
#
Area
Description
Check the bypass:
•
Lift lever K1.
•
Check for jammed media in the bypass, the entrance guide
(1) and the diverter (2).
Check the downward paper path:
•
Open latch K2.
•
Check for jammed media.
•
If necessary, turn knob K2 anti-clockwise until the paper
falls down.
Check the die set:
•
Turn knob K3/K7 clockwise until the puncher is in the
home position. Then the black lines on the knob (3) and
the frame are aligned.
•
Slide the die set out.
•
Check for jammed media.
•
Put the die set back.
Check the bottom of the paper path:
•
Press lever K4 inward and lower the U-channel.
•
Check for jammed media.
•
If necessary, turn knob K4 until the paper falls down.
Check the upward paper path:
•
Open latch K5.
•
Check for jammed media.
•
If necessary, turn knob K5 clockwise until the paper falls
down.
Chapter 6 - Optional finishers and other devices
Troubleshooting
197