Oce VarioPrint 6000 User Manual Operating Information page 138

Change a number of settings in the Settings Editor via the operator panel
Group of settings
'System settings'
How to change a number of settings in the Settings Editor via the operator panel
Note:
The key operator PIN or the system administrator password is required to make changes
in this section.
Touch 'System' -> 'Setup' -> 'Local key operator settings' (under 'Advanced').
1.
Touch the button of the group that contains the setting you want to change or view.
2.
Touch the required setting.
3.
Look up the required information or make the required changes.
4.
If you make a change, touch 'OK' to confirm.
5.
Press 'Close'.
6.
138 Chapter 5 - Working with the operator panel
Available settings
• 'Date and time'
• 'System of mea-
surement'
• 'Time zone'
Short description
The 'System settings' section contains
settings to change the date and time of
the system, or the system of measurement
used. When you change the system of
measurement, all corresponding values
on the system will be changed. For exam-
ple, when you change 'Metric' into 'Impe-
rial', all length values will be displayed in
inches.