Oce VarioPrint 6000 User Manual Operating Information page 27

Component
4 Paper module
5 Engine module
6 Puncher (optional)
7 Stacker
8 Finisher (optional)
9 Stacker/stapler (op-
tional)
Introduction to the main system components
Function
The paper module contains 4 paper trays. The
paper trays contain the media that will be printed.
The default configuration of the system contains
1 paper module. You can add 1 or 2 more paper
modules to the default configuration to increase
the media input capacity (see
on page 36).
The engine module contains the components that
print the media. Access to the engine module is
only required when a paper jam occurs or when
maintenance is required. The doors at the left-hand
side and right-hand side of the engine module give
access to the toner units.
The puncher (iXDP) can make holes in the prints.
The number of holes depends on the die set that
is installed (see 'Replace a die set' on page
The stacker is the output location of a default
configuration. The system supports up to 3 stack-
ers (see 'The output locations' on page
The finisher on top of the stacker is an optional
output location for the print jobs. The finisher can
staple the jobs (see 'The output locations' on page
33).
The stacker/stapler (iMFS) is an optional output
location for the print jobs (see
on page 33). The stacker/stapler supports a large
number of media sizes.
Chapter 4 - Overview of the system components
'The paper modules'
189).
33).
'The output locations'
27