Oce VarioPrint 6000 User Manual Operating Information page 34

The output locations
Component
2 'System out-
put'
3 'Finisher' (op-
tional)
4 'Finisher up-
per output'
34 Chapter 4 - Overview of the system components
Description
The system output is the output location for the following
prints.
• Error prints
• Sample prints
• Configuration reports
• Job tickets
• The test sheets for the media registration.
Make sure that you regularly remove the sheets from the system
output.
The optional finisher contains the following output trays.
• 3 output trays
• 1 upper output (see no. 4 below)
The finisher contains 2 staple cartridges to staple the jobs. The
3 output trays can receive A4, Letter and similar media sizes.
Stapled jobs (A4, Letter and similar media sizes only) go into
the output trays. The total capacity of the output trays is 3,700
sheets (80 g/m² or 20 lb bond).
Note:
The output trays cannot receive tab sheets.
The finisher upper output is part of the finisher. The upper
output can receive all formats. However, the upper output is
mainly intended for large media or jobs with mixed size media.
The maximum capacity of the upper output is 500 sheets (80
g/m² or 20 lb bond).
Note:
The upper output does not contain staple cartridges.
Therefore, the upper output cannot be the output loca-
tion for jobs that require staples.