Oce VarioPrint 6000 User Manual Operating Information page 194

Lubricate the die sets
Illustration
1
2
3
[118] Lubrication points
1. Punch pins
2. Shoulder bolts and springs
3. Felt oil pad
Lubricate the punch pins
Push the die set down until the punch pins protrude from the bottom plate.
1.
Apply a drop of oil to the end of each punch pin.
2.
Wipe down the punch pins.
3.
Make sure that a thin layer of oil remains on the punch pins.
Lubricate the shoulder bolts and springs
Apply a thin layer of oil on the shoulder bolts and springs.
1.
Wipe down the shoulder bolts and springs.
2.
Make sure that a thin layer of oil remains on the shoulder bolts and springs.
Lubricate the felt oil pad
Apply a thin layer of oil along the whole felt oil pad.
1.
Make sure that felt oil pad does not become oversaturated.
194 Chapter 6 - Optional finishers and other devices