Oce VarioPrint 6000 User Manual Operating Information page 123

The 'Output' settings
Workflow profile
'Standard'
'Job by job'
'Check and print'
'Manual planning'
'Unattended'
Note:
The setting 'Link output locations' is only visible when 2 or more equally configured
stackers are available. For example, you cannot link the stackers when 1 stacker is con-
figured for face-up media, while the other is configured for face-down media. Further-
more, it is not possible to link a stacker to a finisher.
Values and effects of the settings
The following table describes the effects of the various values of the settings.
Values and effects of the settings
Setting
'Destination of
print job'
#
'Output' settings
'Next output tray'
'After each job'
'After each job'
'After each job'
'After each job'
'When tray is full'
#
Values Effect
'Scheduled The jobs are immediately sent to the list of
jobs' 'Scheduled jobs'. The machine will print the jobs
in the ripped order. You can do the following to
rearrange the order in which the jobs will be
printed.
•
•
'Waiting jobs' You can manually define the order in which the
jobs will be printed.
'As in job' The submitted jobs go to the destination that is
indicated in the job ticket.
Work with the workflow profiles
'Offset stacking'
'Sets (as in job)'
'Sets (as in job)'
'Sets (as in job)'
'Sets (as in job)'
'Banners'
Move jobs to the list of 'Waiting jobs' or
Use 'To top' to move a job to the top of the
list of 'Scheduled jobs'
job' on page 65).
Chapter 5 - Working with the operator panel
'Link output loca-
tions'
'On'
'On'
'On'
'On'
'Off'
('Give priority to a print
123