Oce VarioPrint 6000 User Manual Operating Information page 161

Num-
ber
2
3
4
Sequence of steps for transaction printing
The following table describes the sequence of steps for transaction printing in general.
#
Actions at the printer side
1. Switch the printer into the transaction
printing mode
2. Select the required job setup via the
operator panel. You must define the
properties of the job setup in the Settings
Editor application on the Controller
3. Load the required media into the paper
trays
4. Place the printer on-line
7. Print the transaction stream
Note:
You must perform all the regular
activities, for example loading the
media, emptying the output loca-
tions, adding supplies and solving
errors
Item
'Connection'
'Print protocol'
'Image shift'
Introduction to the 'Transaction' section
Function
The 'Connection' section gives access to the follow-
ing functions.
• Turn the transaction printing function on or
off
• Put the printer on-line. This is required to
connect the printer to the server
• Select the setup for the transaction stream
Display the active printer description language
(read-only)
Display and change the image shift
Actions on the server side
5. Connect to the printer
6. Start the transaction stream
Chapter 5 - Working with the operator panel 161