Oce VarioPrint 6000 User Manual Operating Information page 174

Handle the media messages
From the list of media, select the media that will be used as the media the controller is
2.
asking for and press 'OK'.
Note that this might be an incorrect media.
The media will now be displayed with the name that is defined in the media catalog.
Select the paper tray where you want to load the required media and press 'OK'.
3.
Load the media.
4.
Close the paper tray.
5.
Press 'OK'.
6.
Now you can assign other media or continue the print job.
How to handle the 'Media message' in the tray-to-media mode
A message on the operator panel indicates that a media is missing. Select one of the fol-
1.
lowing actions as a response to the message.
• Press 'Assign media'.
Continue with step 2 when you select this option.
• Press 'Continue'.
The controller will use the PCL default media and continue the print job.
Note that this might be an incorrect media.
• Press 'Cancel stream'.
The print job is stopped. You can now solve the problem. You will most likely be able
to solve the problem on the server.
Note:
The following steps apply only when you chose to assign a media.
From the list of media, select the media that will be used as the media the controller is
2.
asking for and press 'OK'.
Note that this might be an incorrect media.
Select one of the 16 memory locations of the logical-tray table to be used for the required
3.
media.
Note that the media that was previously allocated to that memory position in the setup
will be overwritten. Then that media will no longer be available to the transaction stream.
Now you can assign other media or continue the print job.
174 Chapter 5 - Working with the operator panel