Oce VarioPrint 6000 User Manual Operating Information page 248

Troubleshooting
Error
Unit recondi-
tioning
The system
cannot deter-
mine if the
output is com-
plete
Overview of possible job errors
Handle job errors
Error
The required
supplies are
not available
The defined
combination
of job settings
is not possible
Overview of the possible toner pollution problems using media with high amounts
of paper dust
When you use media with a high amount of paper dust, you can have problems with
toner pollution of the prints right after the automatic black image cleaning procedure.
Therefore it is advised to enable the 'Paper quality test' (see
on page 133) each time when a new batch of media is used. This is to be sure that the
correct 'Paper quality' setting is still at the right level for this new batch.
248 Chapter 7 - Keeping the printer running
Solution
Follow the instructions
on the operator panel.
Follow the instructions
on the operator panel
and check the output.
#
Solution
Add the required sup-
plies (media, toner and
staples) before the ma-
chine stops printing.
•
The controller cor-
rects the settings.
• You must define a
correct combination
of job settings in the
'Properties' section
of the 'Jobs' view on
the operator panel.
Additional information
After an error was solved, the machine
checks if the print job can continue from
the point where the printing stopped.
When you use cyclic media, you must
probably remove a couple of sheets.
The system can sometimes not determine
if the output is complete. Then you must
check the output. Touch the 'OK' button
when the output is complete.
Additional information
The dashboard helps you to determine
when the supplies are required.
The solution depends on the place where
the job settings are defined.
• When the job settings are defined in
an application or printer driver, the
controller automatically corrects the
settings.
• When you define the job settings on
the operator panel, the operator panel
displays a message that the defined
combination is not possible. The 'OK'
button is disabled.
'Start the Paper quality test '