Adjust the folding shift
Introduction
It can occur that the fold line is not exactly in the correct position. In that case, the
folded output shows a folding shift. If you have a job that contains both folded and non-
folded sheets, the result is that the folded sheets are slightly bigger than the non-folded
sheets. You can correct this by adjusting the fold position in the Settings Editor.
Note:
The folder has two fold plates, referred to as 1 and 2 in the text below.
Corrections for half-fold
If the folded sheets show a folding skew and a folding shift, adjust the folding shift first.
Chapter 6 - Optional finishers and other devices
Adjust the folding shift
217