Oce VarioPrint 6000 User Manual Operating Information page 131

'Enhanced media mode'
Glossy media can cause a collating or stapling error in the finisher. You can set the 'En-
hanced media mode' to 'On' to prevent the error. This will decrease the productivity of
the machine. By factory default, the 'Enhanced media mode' is 'Off'. When you set the
'Enhanced media mode' to 'On' and the machine status is 'Printing...', the dashboard
displays a message that the enhanced media mode is enabled.
The 'Enhanced media mode' is only available on machines that are equipped with an
optional finisher (see
'Paper quality'
Good media is best run with the highest paper quality setting: 'Normal'.
Lower grade media with respect to paper dust, such as some book papers for example,
can leave more paper dust in the machine. This can lead to ghost images on prints directly
after the black image cleaning procedure or to ghost images of previous pages on prints.
When you use lower grade media, you can improve the print quality, with respect to
these undesired ghost images, by changing the value of the 'Paper quality' setting to 'Low'
or even 'Lower'. However, this affects the productivity by almost 5 and 10% respectively.
Please refer to the Troubleshooting chapter for more information (see
on page 247).
'Paper quality test'
This test helps you to check if the correct 'Paper quality' setting is set. In the Settings
Editor, you can select the media for this test. It is advised to choose the media used for
the job. Or, in other cases, choose media which covers the width of the media used as a
minimum. When you start the 'Paper quality test', the machine sends 5 empty sheets of
the selected media to the system output. This is done after each of the next 5 black image
cleaning procedures. Keep in mind that this can last 2500, 1250 and 1000 sheets when
the 'Paper quality' setting is set to 'Normal', 'Low' and 'Lower' respectively. Then the
test stops and the print job continues without interruption.
Check the last set (fifth) of the empty sheets to see if the 'Paper quality' setting is cleaning
the print process properly.
Note:
When the system goes into standby mode before the 'Paper quality test' has finished,
the 'Paper quality test' starts again.
Before you begin
On the operator panel, press the 'System' button.
1.
Press 'Setup'.
2.
Touch the 'Advanced media settings' button in the 'Advanced' section.
3.
Enter the maintenance PIN when you change a setting.
4.
'The output locations' on page
Chapter 5 - Working with the operator panel
Change the advanced media settings
33).
'Troubleshooting'
131