Folding shift
It is possible for the fold line not to be
exactly in the in the middle of the sheet.
If you have a job that contains both fold-
ed and non-folded sheets, the result is that
the folded sheets are slightly bigger than
your non-folded sheets.
You can correct this by adjusting the fold
position in the Settings Editor (see
the folding shift' on page
Folding skew
If you want to change from a Z-fold to a
half-fold or visa versa, it is possible for the
fold line not to be exactly straight and for
your folded output to show a folding
skew.
You can correct this folding skew using
the knob in the puncher/folder (see
'Adjust
just the folding skew' on page
217).
Chapter 6 - Optional finishers and other devices
What is a folding shift and a folding skew?
'Ad-
214).
213