Making Copies - Xerox WorkCentre 5845 Getting Started Manual

Getting Started

Making Copies

When you press the Start button to make a copy, the device scans your originals and temporarily stores
the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login details
to access the Copy features.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch the
documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and register
it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen. The copy features are displayed.
5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.
6. Select any options required.
7. Enter the number of prints required using the numeric keypad on the control panel.
8. Press the Start button on the control panel to scan the original.
9. Remove the original from the document feeder or document glass when scanning has completed.
The job enters the job list ready for processing.
10. Press the Job Status button on the device control panel to view the job list and check the status of
the job.
11. If your job remains held in the Active Jobs list, the device needs you to supply additional resources,
such as paper or staples before it can complete the job. To find out what resources are needed,
select the job and then select the Details button. Once the resources are available the job will print.
®
38 WorkCentre 5845/5855/5865/5875/5890
Getting Started Guide