Ps Menu - Genicom Intelliprint ML450 User Manual

4-12 GENICOM LN45 and Intelliprint mL450 User Guide

PS Menu

Network 1 Setup
This submenu allows you
to set up the Network
interface.
PS Menu
The PS Menu provides access to the PostScript settings. Use the following procedure to enter the PS Menu:
Press the MENU button on the control panel.
1.
Press the NEXT button until the text " PS Menu " is shown on the second line of the display.
2.
Press the SELECT button to enter the PS menu.
3.
Press the NEXT button to move through the submenus: Print PS Errors , and Manual Feed TO.
4.
Press the SELECT button to enter a submenu.
5.
Use the procedures in the following table to access and change the PostScript settings:
6.
Publication No. GEG-99126
Interpreter: Interpreter:
Auto Switch Auto Switch
PCL
PostScript 3
Format: Format:
Raw Raw
Normal
Binary
Network Network Channel:
Channel: DEC LAT, AppleTalk,
Netware TCP/IP
Network Network Address:
Address:
IP Address:
IP Address: (user-specified)
(user-specified)
Subnet Mask:
Subnet Mask: (user-specified)
(user-specified)
Default Router:
Default (user-specified)
Router:
(user-specified) LPD Banner:
On
LPD Banner: Off
On
DHCP:
DHCP: Off
Off On
Network Frame:
Network 802.3, Ethernet II,
Frame: 802.2 SNAP, 802.2
Auto-Sense
Delay Out Close:
Delay Out Off
Close: On
Off
Genicom
1. Press NEXT or PREVIOUS to move among the
submenus.
2. Press SELECT to choose a submenu.
3. Press NEXT or PREVIOUS to scroll through the
settings.
4. Press SELECT to save this setting.
Aug 01