Configuration On The Machine - Xerox 4590 System Administration Manual

2. C on f ig u rat i on
2- 1 0

Configuration on the machine

This section describes the configuration procedure to enable
Internet Printing (IPP) on the machine. First enable the IPP port,
then set the IP address.
NOTE 1: The configuration can also be performed using IP
configuration tools included in CentreWare Internet Services or
CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
Display the System Administrator Menu screen.
1.
a. Press the Log In/Out button.
b. Enter the UserID using the numeric keypad and select
Confirm.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select System Settings.
Enable the IPP port.
2.
a. Select System Settings.
b. Select Network Settings.
c. Select Port Settings.
d. Select IPP and then select Change Settings.
e. Select IPP - Port and select Change Settings.
f. Select Enable and then select Save.
3. Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select Close repeatedly until the Network Settings
screen is displayed.
b. Select Protocol Settings.
c. Select TCP/IP - Get IP Address and select Change
Settings.
d. Select one from DHCP, BOOTP, RARP, DHCP/Autonet or
Manual. If you select anything other than Manual, proceed
to step 4.
NOTE: When using a DHCP server, also configure the WINS
(Windows Internet Name Service) server.
Xe r o x 45 90 / 4110 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e