Configuring The E-Mail Environment - Xerox 4590 System Administration Manual

5. U s i ng t h e S c an S e r v i ce

Configuring the E-mail environment

5- 4
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address,
enter "0.0.0.0."
Select Close repeatedly until the System Settings screen is
4.
displayed.
Select Exit.
5.
After the machine is restarted, print out the Printer Settings
6.
List to confirm that the mail send port is enabled and TCP/IP is
configured.
This section describes the configuration procedure to use the
scanner (mail transmission) function.
NOTE 1: The configuration can also be performed using
CentreWare Internet Services.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
Display the System Administrator Menu screen.
1.
a. Press the Log In/Out button.
b. Enter the UserID using the numeric keypad and then
select Confirm.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select System Settings.
Xe r o x 45 90 / 4110 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e