Configuration On The Machine - Xerox 4595 System Administration Manual

2. C on f ig u r at i on
2- 2

Configuration on the machine

This section describes the configuration procedure to use TCP/IP
(LPD/Port 9100) protocol on the machine. First enable the LPD
Port or Port 9100 port, then assign the IP address.
NOTE 1: The configuration can also be performed using
CentreWare Internet Services or CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
1. Display the System Administrator Menu screen.
a. Press the Log In/Out button.
b. Enter the UserID using the numeric keypad and select
Confirm.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select System Settings.
Enable either the LPD port or the Port 9100 port as
2.
appropriate. In this example, the LPD port is enabled.
a. Select System Settings.
b. Select Network Settings.
c. Select Port Settings.
d. Select LPD and then select Change Settings.
e. Select LPD - Port and select Change Settings.
f. Select Enable and then select Save.
3. Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select Close repeatedly until the Network Settings
screen is displayed.
b. Select Protocol Settings.
c. Select TCP/IP - Get IP Address and select Change
Settings.
d. Select one from DHCP, BOOTP, RARP, DHCP/Autonet or
Manual. If you select anything other than Manual, proceed
to step 4.
NOTE: When using a DHCP server, also configure the WINS
(Windows Internet Name Service) server.
X e r o x 4 5 95 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e