Example - GE MULTILINK ML2400 Instruction Manual

CHAPTER 16: SNMP

16.2.2 Example

MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
trap <add|delete> id=<id> [type=<v1|v2|inform>] [host=<host-ip>]
[community=<string>] [port=<1-65534>]
The show-trap command shows the configured trap stations in tabular format. The
argument is optional and is the number corresponding to the trap entry number in the
table.
show-trap [id=<id#>]
The command specifies the mapping from a source/community pair to a
com2sec
security name. Up to 10 entries can be specified. This part of the View based Access
Control Model (VACM) as defined in RFC 2275.
com2sec <add|delete> id=<id> [secname=<name>] [source=<source>]
[community=<community>]
The command defines the mapping from sec model or a sec name to a group. A
group
sec model is one of v1, v2c, or usm. Up to 10 entries can be specified. This part of the View
based Access Control Model (VACM) as defined in RFC 2275.
group <add|delete> id=<id> [groupname=<name>] [model=<v1|v2c|usm>]
[com2secid=<com2sec-id>]
The command displays all or specific group entries. The
show-group
optional and is the number corresponding to the group entry number in the table
show-group [id=<id>]
The command defines a manager or group or manager stations what it can access
view
inside the MIB object tree. Up to 10 entries can be specified. This part of the View based
Access Control Model (VACM) as defined in RFC 2275
view <add|delete> id=<id> [viewname=<name>] [type=<included|excluded>]
[subtree=<oid>] [mask=<hex-string>]
The command display all or specific view entries. The
show-view
and is the number corresponding to the view entry number in the table.
show-view [id=<id>]
The command adds user entries. The ML2400 allows up to 5 users to be added.
user
Currently, the ML2400 agent only support
for authentication.
auth-des priv
user <add|delete> id=<id> [username=<name>] [usertype=<readonly|readwrite>]
[authpass=<pass-phrase>]
[privpass=<pass-phrase>] [level=<noauth|auth|priv>] [subtree=<oid>]
The command displays all or specific view entries. The
show-user
number corresponding to the view entry number in the table.
show-user [id=<id>]
The following example shows how to configure SNMP.
id
and for v3 authentication and
noauth auth-md5
id
SNMP
id
argument is
id
argument is optional
is optional and is the
16–5