GE MULTILINK ML2400 Instruction Manual page 208

RAPID SPANNING TREE PROTOCOL
Example 13-4: Configuring RSTP
ML2400#
rstp
ML2400(rstp)##
show stp config
RSTP CONFIGURATION
------------------
Rapid STP/STP Enabled(Global) : NO
ML2400(rstp)##
show active-stp
Current Active Mode: RSTP.
RSTP is Disabled.
ML2400(rstp)##
rstp enable
Successfully set the RSTP status
ML2400(rstp)##
show active-stp
Current Active Mode: RSTP.
RSTP is Enabled.
ML2400(rstp)##
show stp config
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : YES
RSTP/STP Enabled Ports
Protocol
Bridge ID
Bridge Priority
Bridge Forward Delay
Bridge Hello Time
Bridge Max Age
Root Port
Root Path Cost
Designated Root
Designated Root Priority
Root Bridge Forward Delay
Root Bridge Hello Time
Root Bridge Max Age
Topology Change Count
Time Since Topology Chg
ML2400(rstp)##
show stp ports
RSTP Port Configuration
--------------------------------------------------------------------------------------
Port# Type
--------------------------------------------------------------------------------------
09 TP(10/100)
10 TP(10/100)
11 TP(10/100)
12 TP(10/100)
13 TP(10/100)
14 TP(10/100)
15 TP(10/100)
16 TP(10/100)
ML2400(rstp)##
forceversion rstp
Error: Force Version already set to Normal RSTP
(continued on next page)
13–10
: 9,10,11,12,13,14,15,16
: Normal RSTP
: 80:00:00:20:06:25:ed:89
: 0
: 15
: 02
: 20
: 0
: 0
: 80:00:00:20:06:25:ed:89
: 0
: 15
: 02
: 20
: 0
: 33
Priority Path Cost State
128 2000000 Forwarding
128 2000000 Disabled
128 2000000 Disabled
128 2000000 Disabled
128 200000 Forwarding
128 2000000 Disabled
128 2000000 Disabled
128 2000000 Disabled
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
CHAPTER 13: RAPID SPANNING TREE PROTOCOL
Check the status of STP or RSTP. These
commands show if STP or RSTP is
enabled.
Des. Bridge
80:00:00:20:06:25:ed:89
80:00:00:20:06:25:ed:89
Des. Port
00:09
00:0a
00:0b
00:0c
00:0d
00:0e
00:0f
00:10