MISCELLANEOUS COMMANDS
17–22
The port mirroring commands are shown below. Refer to Port Mirroring on page 9–1 for
additional details.
•
help port-mirror
•
: enables/disables port mirroring functionality
prtmr
•
: defines the port mirroring ports
setport
The port security commands are shown below. Refer to Securing Access on page 6–1 for
additional details.
•
: sets the action type of secured port
action
•
: allows MAC addressing per port
allow
•
help port-security
•
: enables/disables security for a single port or group of ports
learn
•
: enables/disables security in system
ps
•
: removes MAC addressing per port
remove
•
: sets the signal type of the secured port
signal
The quality of service (QoS) commands are shown below. Refer to QoS Overview on page
14–1 for additional details.
•
help qos
•
: configures QOS configuration usage
setqos
•
set-untag
•
: sets the port priority weights for all the ports in all the device
set-weight
•
show-portweight
The remote monitoring (RMON) commands are shown below. Refer to Configuring RMON
on page 16–13 for additional details.
•
: sets the owner for the alarm group
alarm
•
: sets the owner for the event group
event
•
help rmon
: sets the owner for the history group
•
history
•
: sets the owner for the statistics group
statistics
The Rapid Spanning Tree Protocol (RSTP) commands are shown below. Refer to Rapid
Spanning Tree Protocol on page 13–1 for additional details.
•
: sets the path cost of ports
cost
•
: set the force version of STP
forceversion
•
help rstp
•
lll
•
: sets the RSTP administration status of ports
port
•
: changes the priority of ports or bridge
priority
•
: changes the RSTP administrative status of the bridge
rstp
•
show-forceversion
•
: shows the port mode status
show-mode
•
: shows the bridge time parameters
show-timers
•
: changes the bridge time parameters
timers
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
CHAPTER 17: MISCELLANEOUS COMMANDS
: displays the current port weight priority
: shows the current force version of RSTP