CHAPTER 17: MISCELLANEOUS COMMANDS
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
The Simple Mail Transfer Protocol (SMTP) commands for e-mail are shown below. Refer to
E-mail on page 17–6 for additional details.
•
: adds a recipient
add
•
: deletes a recipient
delete
•
help smtp
•
: sends e-mail
sendmail
•
: sets the global SMTP server configuration
server
•
: enables/disables SMTP e-mail alert
smtp
The Simple Network Management Protocol (SNMP) commands are shown below. Refer to
SNMP on page 16–1 for additional details.
•
: enable/disables the authentication traps
authentraps
•
: configures SNMP community names
community
•
help snmp
•
: adds or deletes the SNMP manager IP
mgrip
•
: configures system name, contact, or location
setvar
•
: adds or deletes a trap receiver
traps
The Simple Network Time Protocol (SNTP) commands are shown below. Refer to Network
Time on page 5–10 for additional details.
•
: deletes the SNTP server from SNTP server database
delete
•
help sntp
•
: adds SNTP server into the SNTP server database
setsntp
•
: configures parameters for SNTP system
sntp
•
: sets the interval for synchronization time with an NTP server
sync
The Spanning Tree Protocol (STP) commands are shown below. Refer to Spanning Tree
Protocol (STP) on page 12–1 for additional details.
•
cost
•
lll
•
port
•
priority
•
s-ring
•
stp
•
timers
The user commands are shown below. Refer to the User Management on page 1–14 for
additional details.
•
: adds a new user
add
•
: changes the user access permissions
chlevel
•
: deletes an existing user
delete
•
help user
•
: change the user password
passwd
•
tacplus
•
tacserver
MISCELLANEOUS COMMANDS
17–23