Ping; Ping Through The Command Line Interface - GE MULTILINK ML2400 Instruction Manual

CHAPTER 17: MISCELLANEOUS COMMANDS

17.6 Ping

17.6.1 Ping through the Command Line Interface

17.6.2 Ping through EnerVista Secure Web Management Software
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
The command can be used to test connectivity to other devices as well as checking
ping
to see if the IP address is setup correctly. The command syntax is:
ping <ipaddress> [count=<1-999>]
[timeout=<1-256>]
For example:
ML2400#
ping 3.94.248.61
3.94.248.61 is alive, count 1, time = 40ms
ML2400#
ping 3.94.248.61 count=3
3.94.248.61 is alive, count 1, time = 20ms
3.94.248.61 is alive, count 2, time = 20ms
3.94.248.61 is alive, count 3, time = 40ms
ML2400#
Many devices do not respond to
device responds or the network allows the ping packets to propagate.
The command can be used from EnerVista Secure Web Management Software to
ping
test connectivity to other devices as well as checking to see if the IP address is correct.
Select the Administration > Ping menu item to use ping.
As mentioned earlier, many devices do not respond to
the target device responds or the network allows ping packets to propagate.
or block commands. Make sure that the target
ping ping
ping
MISCELLANEOUS COMMANDS
commands. Make sure that
17–13