Table of Contents
Advertisement
Proceed as follows:
2.
3.
4.
Close the left and center door at the back of the printing system.
5.
Enter on the operator panel whether a new fine filter has been fitted:
•
The message on the operator panel is automatically deleted, and the replacement
of the fine filter is recorded in the <Consumables history> menu.
•
If the fine filter was not replaced,
the process is documented in the <Consumables history> menu.
Status display in the Consumables history:
A29246-X20-X-4-7680 / fa703.fm
7.3.11 Replacing the fine filter
Clean opening with a round brush(see
section Cleaning materials and
equipment, page 365). Before use,
sharply angle round brush and insert
into the opening.
For function control, the LED must light
up when the round brush is being
inserted and go off when it is removed.
Tighten the plastic screw again.
2 of 3
335
Advertisement
Table of Contents
