Table of Contents
Advertisement
7.3.8 Replacing the fuser roller
Proceed as follows:
4.
5.
6.
Installing the heater (see section Install heater, page 307).
7.
318
Tighten the three wing screws for
attach the fuser roller insert one after
the other step by step. Only use a max.
of three turns for each screw.
Proceed from one wing screw to the
next until the flange of the fuser roller
insert is secure against the side plate.
Swivel on the waste collector and lock
with the pressure pin.
Swivel on active filter unit by the
handle to the stop point.
A29246-X20-X-4-7680 / fa703.fm
3 of 4
Advertisement
Table of Contents
