Oce VarioStream 7000 SINGLE Operating Manual page 111

Proceed as follows:
14. Press the EJECT key briefly. The paper is now automatically transported through the
fuser station to the stacker and placed there in the correct order.
An automatic cleaning phase is now performed. The message "Cleaning cycle
underway" is displayed in the operator panel.
15. Click on the following button:
The "Check paper position" message is displayed in the P mode in the operator
panel.
Important
In P mode, in order for printing to begin on the upper page at every job start, there
must be a positive fold (^) at the adjustment ruler marking.
16.
17. Click on the following button again:
When the message "Cleaning cycle underway" disappears, the printing system is
ready to print.
18. Close the doors on the front of the printing system.
19. Close cover hood.
A29246-X20-X-4-7680 / fa502_pinfed.fm
5.4.1 Semi-automatic paper insertion
Adjust a fold perforation so that it lies
at the adjustment ruler marking that
corresponds to the paper format length
(fold length).
111