Table of Contents
Advertisement
7.3.3 Replacing the cleaning brush
Proceed as follows:
6.
7.
Swivel on the door to the photoconductor drum and close the lever.
8.
Close both doors and the cover at the front of the printing system.
9.
Enter on the operator panel whether a new cleaning brush was fitted:
•
•
10. Click the following button on the operator panel to complete cleaning brush
replacement:
All printing system assemblies are checked (duration approx. 2-3 minutes) before the
printing system is switched to the "Ready" status.
In both cases, the message on the operator panel is automatically deleted, the
replacement of the cleaning brush is recorded in the <Consumables history> menu
and the consumable counter is reset.
268
The message on the operator panel is deleted automatically, the replacement of
the cleaning brush is recorded in the <Consumables history> menu and the
consumable counter is reset.
The consumable counter is not reset.
Press the cover cap with the cleaning
brush against the opening and tighten
the two knurled screws of the brush
cover cap.
A29246-X20-X-4-7680 / fa701.fm
2 of 2
Advertisement
Table of Contents
