Table of Contents
Advertisement
Proceed as follows:
12.
13. Close the front and side door of the fuser station.
14. Enter on the operator panel whether a new heater has been fitted:
•
The message on the operator panel is deleted automatically, the replacement of
the heater is recorded in the <Consumables history> menu.
•
If the heater was not replaced, but only removed and then re-inserted for control
purposes, for example,
the process is documented in the <Consumables history> menu.
Status display in the Consumables history:
15. Click the following button on the operator panel to complete heater replacement:
All printing system assemblies are checked (duration approx. 2-3 minutes) before
the printing system is switched to the "Ready" status.
In both cases, the message on the operator panel is automatically deleted, and the
replacement of the heater is recorded in the <Consumables history> menu.
A29246-X20-X-4-7680 / fa703.fm
7.3.7 Replacing the heater
Swivel on oiling unit and turn the oiling
unit turning knob to the right.
5 of 5
311
Advertisement
Table of Contents
