Wiring Terminals - Toshiba PROSEC T1 User Manual

4.3 Wiring terminals

!
CAUTION
The terminal arrangement of each T1 Series model are shown below.
The terminal screw size is M3.5. Use crimp-style terminals of 7 mm width or less useable
for M3.5.
The terminal blocks of the T1-16 are not removable (fixed). On the other hand, the
terminal blocks of the T1-28, T1-40 and T1-40S are removable. However, be sure to turn
off power before removing or replacing the terminal blocks.
NOTE
· T1-16
T1-MDR16 ... AC power supply, Dry contact input type
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
1. Turn off power before wiring to minimize the risk of electrical shock.
2. Exposed conductive parts of wire can cause electrical shock. Use
crimp-style terminals with insulating sheath or insulating tape to cover
the conductive parts. Also close the terminal covers securely on the
terminal blocks when wiring has been completed.
3. Turn off power before removing or replacing units, modules, terminal
blocks or wires. Failure to do so can cause electrical shock or damage
to the T1/T1S and related equipment.
For input and output signal connections, refer to sections 2.4 and 3.
L 0 2 4 6
-
N 1 3 5
T1-16
Vin
+ 21 23 25 27
20 22 24 26
C0
4. Installation and Wiring
7
IN
OUT
C1
Basic Hardware and Function
6F3B0250
71