Installing The Unit - Toshiba PROSEC T1 User Manual

4.2 Installing the unit

!
CAUTION
NOTE
Installation precautions:
· Because the T1/T1S is not dust-proof, install it in a dust-proof enclosure.
· Do not install the unit directly above equipment that generates a large amount of heat,
such as a heater, transformer, or large-capacity resistor.
· Do not install the unit within 200 mm of a high-voltage or high-power cables.
· Allow at least 70 mm on all sides of the unit for ventilation.
· For safely during maintenance and operation, install the unit as far as possible from
high-voltage or power equipment. Alternatively, keep the unit separate using a metal
plate or similar separator.
· If a high-frequency equipment is installed in the enclosure together with the T1/T1S,
special attention is required for grounding. See section 4.4.
· Be sure to install the unit vertically with keeping the power terminals upside. Do not
install the unit horizontally or upside-down for safety reason.
· Use M4 size screws to mount the T1/T1S.
(Recommended torque: 1.47 N×m = 15 kgf×cm)
Upward
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
1. Improper installation directions or insufficient installation can cause fire
or the units to drop. Install the T1/T1S and related equipment in
accordance with the instructions described in this section.
2. Turn off power before installing or removing any units, modules, racks
or terminal blocks. Failure to do so can cause electrical shock or
damage to the T1/T1S and related equipment.
3. Entering wire scraps or other foreign debris into to the T1/T1S and
related equipment can cause fire or malfunction. Pay attention to prevent
entering them into the T1 and related equipment during installation and
wiring.
The T1/T1S basic unit and the expansion unit come equipped with a bracket at
the rear for mounting on a 35 mm DIN rail. However, no DIN rail bracket is
provided on the expansion rack.
IN
PROSEC
TOSHIBA T1 MDR40
OUT
4. Installation and Wiring
Mount the T1 on a vertical panel.
All other mounting positions are not
acceptable.
Basic Hardware and Function
6F3B0250
69