Toshiba PROSEC T1 User Manual page 85

The operation modes are switched by the mode control switch provided on the T1/T1S
and the mode control commands issued from the programming tool.
The mode transition conditions are shown below.
'
HOLD
'
Œ
Mode control switch is in R (RUN) side.
•
Mode control switch is in H (HALT) side.
Ž
Mode control switch is turned to H (HALT) side, or HALT command is issued from
the programming tool.
•
Mode control switch is turned to R (RUN) side, or RUN command is issued from
the programming tool.
•
Force RUN (RUN-F) command is issued from the programming tool.
'
HOLD command is issued from the programming tool.
'
HOLD Cancel command is issued from the programming tool.
"
Error Reset command is issued from the programming tool.
NOTE
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Œ
RUN
'
Ž
'
RUN-F
(dotted line) Error is detected by self-diagnosis.
The commands from the programming tool are available when the mode
control switch is in R (RUN) side.
5. Operating System Overview
(Power ON)
•
Ž
•
•
Ž
ERROR
Basic Hardware and Function
6F3B0250
HALT
"
83