Iopn.diskx Disable Mirrored Disk - HP NetServer AA 6200 Administrator's Manual

If bad block remapping is turned on, but later you determine that automatic
Results
bad block remapping is not desirable, invoke this command to stop the SCSI
software from automatically remapping bad blocks for a device.
It is possible that bad block remapping might cause file system information
loss to occur, depending on whether the sector in which the bad block was
encountered is in use by your file system. If the sector is not in use by your
file system, bad block remapping causes no loss of file system information.
See Also
IOPn.Diskx Enable Bad Block Remap
IOPn.ScsiProvider Show Bad Block Status
IOPn.ScsiProvider Show Mirror Status

IOPn.Diskx Disable Mirrored Disk

This command disables an individual mirrored SCSI disk that is online or offline.
If you use this command in the context of performing a mirror copy, you might decide to disable
the target of a running mirror copy to halt the mirror copy. In that case, you would disable an
online disk. To prevent a mirror copy from beginning, you might decide to disable the target of
a pending mirror copy. In this case, you would disable an offline disk.
Command IOPn.Diskx Disable Mirrored Disk
Console Syntax MTCCONS IOPn.Diskx Disable Mirrored Disk
n – the ID number of the IOP (1 or 2)
Variables
x – the ID number of the SCSI disk
The online or offline mirrored disk, indicated by
Results
immediately.
Once a disk is disabled, you can use it again only if you explicitly enable it.
A disk remains disabled across IOP reboots.
Warning: Do not disable all members of a mirror set, and do not
See Also
IOPn.Diskx Enable Mirrored Disk
IOPn.ScsiProvider Show Mirror Status
Commands
disable the source of a mirror copy or Windows loses
access to the mirror set.
is disabled
Diskx,
5-29