IOPn.Ethernetx Enable Operation
This command enables an Ethernet adapter that was disabled.
Note:
For information on enabling a faulted Ethernet adapter, refer to
Command
IOPn.Ethernetx Enable Operation
Console Syntax MTCCONS IOPn.ETHERNETx Enable Operation
n – the ID number of the IOP (1 or 2)
Variables
x – the ID number of the Ethernet adapter
Check the Windows Event Viewer on the CE for the following message:
Results
See Also
IOPn.Ethernetx Disable Operation
IOPn.Ethernetx Reset Port Counters
The Ethernet Provider maintains error counters and statistics for each configured Ethernet
adapter. This command initializes the counters to zero for the specified adapter on the specified
IOP. This command has no effect on the counters maintained by the third-party Ethernet adapter
driver.
Command
IOPn.Ethernetx Reset Port Counters
Console Syntax MTCCONS IOPn.ETHERNETx Reset Port Counters
n – the ID number of the IOP (1 or 2)
Variables
x – the ID number of the Ethernet adapter
See Also
IOPn.Ethernetx Show Port Counters
5-36
IOPn.MtcDsl status: Physical device Ethernet adapter on IOPn of
logical device Ethernetx on IOPn is online.
HP Netserver AA Solution Administrator's Guide
Chapter
9.