Server Shutdown Operation - HP NetServer AA 6200 Administrator's Manual

Server Shutdown Operation

This command shuts down the CE's operating system and then shuts down the operating system
on each available IOP.
Note: This command is the preferred method for shutting down the Endurance server.
Command Server Shutdown Operation From IOPx
Console Syntax MTCCONS Server Shutdown Operation From IOPx
x – the ID number of the IOP (1 or 2)
Variables
The monitor on the specified IOP initiates a shutdown of the Endurance
Results
server. First, a request is issued by the monitor on the specified IOP to the CE
Endurance Management service to shut down the operating system if the CE
operating system is booted. The CE Endurance Management service initiates
the CE operating system shutdown. When complete, the monitor on the
specified IOP initiates a shutdown of the remote IOP (if it is available),
followed by a shutdown of the local IOP. The Endurance server reboots when
the IOPs and CEs become available.
If the system fails to shut down, perform the following steps:
•
•
•
See Also
CE Disable Auto Boot
CE Disable Auto Synch
CE_O/S Shutdown
IOP Shutdown Operation
IOPn.Monitor Enable Auto Start
Server Shutdown Without IOP Reboot
Tuple Shutdown Operation
5-80
Check the status of the Endurance server in the Endurance Manager
Main window on the IOPs and the CEs. Determine which, if any, system
elements were removed.
Review the Windows Event Viewer for a message that indicates that the
command failed.
Shut down the Endurance server using the procedures in
HP Netserver AA Solution Administrator's Guide
Chapter 9.