Iop Enable Operation - HP NetServer AA 6200 Administrator's Manual

To verify that IOPn has been disabled, either:
Results
•
•
See Also

IOP Enable Operation

IOP Shutdown Operation
IOPn.Monitor Show Configuration
IOP Enable Operation
This command enables the specified IOP that was disabled or faulted. The IOP attempts to
rejoin the Endurance server immediately or when it reboots the Windows operating system.
Command IOPn Enable Operation From IOPx
Console Syntax MTCCONS IOPn Enable Operation From IOPx
n – the ID number of the IOP (1 or 2) you want to enable
Variables
x – the ID number of the IOP (1 or 2) that issues the enable command
To verify that IOPn has been enabled, either:
Results
•
•
See Also
IOP Disable Operation
IOP Shutdown Operation
IOPn.Monitor Show Configuration
5-22
Check the Windows Event Viewer for a message that indicates that IOP
has been shut down, disabled, or removed from service.
Issue an IOP Show Configuration command on the CE. Then verify that
IOPn is disabled and any associated components (such as IOPn.MIC) are
offline.
Issue an IOP Show Configuration command from either IOP.
Check the Windows Event Viewer on the CE (or on the IOP that you
enabled) for a message that indicates that the IOP is enabled.
HP Netserver AA Solution Administrator's Guide