n – the ID number of the IOP (1 or 2)
Variables
x – the timeout value that you want to set. The timeout range is 0 to 300
seconds. If the timeout is 0, arbitration is disabled (default), and input is
accepted from both IOPs.
See Also
IOPn.InputProvider Show Arbitration Timeout
IOPn.InputProvider Set Hotkey Value
This command defines the hotkey sequence that toggles input devices between the IOP and the
CEs. By default,
<Ctrl><Shift>F12
Command
IOPn.InputProvider Set Hotkey Value x
Console Syntax MTCCONS IOPn.InputProvider Set Hotkey Value x
n – the ID number of the IOP (1 or 2)
Variables
x – the hotkey value that you want to define. Hotkeys are a minimum of two
The default hotkey is
See Also
IOPn.InputProvider Show Hotkey
IOPn.InputProvider Show Hotkey Value
Commands
is the hotkey sequence.
values. The hotkey must contain at least one value from Column A and
one value from Column B:
1
Column A
<Shift>
<Ctrl>
<Alt>
1
Must use at least one, and up to three, unique values
from Column A.
2
Must use only one value from Column B
<Ctrl><Shift>F12
2
Column B
F1 through F12
Insert
Home
Page Up
Page Down
End
Delete
.
5-51