HP NetServer AA 6200 Administrator's Manual page 246

Step Action
5 Initialize the Endurance sector on the
replacement disk:
• From the application task bar,
select Start
Marathon Endurance
Endurance Manager.
• From the Endurance Manager,
issue the command
IOPn.Diskx Reset
Endurance Sector
6 If the local IOP is not enabled, enable
it now:
• From the application task bar,
select Start
Marathon Endurance
Endurance Manager.
• From the Endurance Manager,
issue the command IOPn
Enable Operation From
IOP1 .
7 Verify that all mirror sets are Current,
Started, or Pending.
The destination IOP is the local IOP
in which the replacement drive was
installed.
8 Verify that all mirror copies complete.
Note: If any of the above steps do not perform as documented, contact your service
provider for assistance.
9-30
Notes
Programs
• Substitute for n the number of the IOP in which
• Substitute for x the number of the CE disk of the
.
Verify that the IOPs are joined and both are online
(bright green on the Endurance Manager display).
Programs
Using Endurance Manager, in the Last Mirror Copy
Status WIndow, determine the status of all mirror
copies that may be required. Refer to
detailed information about how to run and use the
Endurance Manager.
Refer to
how to run and use the Endurance Manager.
the replacement disk was installed.
mirror set in which it was a member. For example:
IOP2.Disk1 Reset Endurance Sector
Chapter 4 for detailed information about
HP Netserver AA Solution Administrator's Guide
Chapter 4 for