IOPn.Monitor Show Client Status
This command displays the status of the clients listed in the ClientList Registry parameter on
the specified IOP. If no clients are specified in the client list, the following error message
displays:
An invalid parameter was provided by the caller.
Command
IOPn.Monitor Show Client Status
Console Syntax MTCCONS IOPn.Monitor Show Client Status
n – the ID number of the IOP (1 or 2)
Variables
Results
Value
Monitor Client Id
Registration Flag
Client state
Client substate
5-68
Table 5-28 Monitor Client Status
Meaning
Client ID of an Endurance software component that registers with
the monitor
True indicates that the client has registered with the monitor
Client states (None, Ready, Active, Failed)
Client substates (None, Join_Init, Merge_Init, Updating)
HP Netserver AA Solution Administrator's Guide