Configuring An Ipv4 Over Ipv4 Tunnel - HP 6125XLG Configuration Manual

C:\>ping 2001::5efe:1.1.1.1
Pinging 2001::5efe:1.1.1.1 with 32 bytes of data:
Reply from 2001::5efe:1.1.1.1: time=1ms
Reply from 2001::5efe:1.1.1.1: time=1ms
Reply from 2001::5efe:1.1.1.1: time=1ms
Reply from 2001::5efe:1.1.1.1: time=1ms
Ping statistics for 2001::5efe:1.1.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 1ms, Average = 1ms

Configuring an IPv4 over IPv4 tunnel

Follow these guidelines when you configure an IPv4 over IPv4 tunnel:
• The destination address specified for the local tunnel interface must be the source address specified
for the peer tunnel interface, and vice versa.
Two or more local tunnel interfaces using the same encapsulation protocol must have different
•
source and destination addresses.
• The IPv4 address of the local tunnel interface cannot be on the same subnet as the destination
address configured on the tunnel interface.
If the destination IPv4 network is not on the same subnet as the IPv4 address of the local tunnel
•
interface, you must configure a route destined for the destination IPv4 network through the tunnel
interface. You can configure a static route, and specify the local tunnel interface as the egress
interface or specify the IPv4 address of the peer tunnel interface as the next hop. Alternatively, you
can enable a dynamic routing protocol on both tunnel interfaces to achieve the same purpose. For
the detailed configuration, see Layer 3—IP Routing Configuration Guide.
The destination address of the route passing the tunnel interface must not be on the same subnet as
•
the destination address configured on the tunnel interface.
To configure an IPv4 over IPv4 tunnel:
Step
1. Enter system view.
2. Enter IPv4 over IPv4 tunnel
interface view.
3. Configure an IPv4 address for
the tunnel interface.
4. Configure a source address or
source interface for the tunnel
interface.
Command
system-view
interface tunnel number
[ mode ipv4-ipv4 ]
ip address ip-address { mask
| mask-length } [ sub ]
source { ip-address |
interface-type
interface-number }
173
Remarks
N/A
N/A
By default, no IPv4 address is
configured for the tunnel interface.
By default, no source address or source
interface is configured for the tunnel
interface.
The specified source address or the IPv6
address of the specified source interface
is used as the source IP address of
tunneled packets.