Intermec MobileLAN access WA21 System Manual page 44

Chapter 1 — Getting Started
30
• upgrade the access point software. For help, see the online help and
"Upgrading the Access Points" in Chapter 8.
After you configure the IP address, you can use a web browser or a telnet
session to complete the configuration.
To use the MobileLAN access Utility, you must have the following:
• Windows 95-OSR2/98SE/ME, Windows NT4.0/2000/XP
• Access points with software release 1.61 or later
Note: You need to install the MobileLAN access Utility on a PC that is on
the same IP subnet as the access point. Or, you can install it on a PC that
is communicating wirelessly (configured to Intermec's default radio
settings) to the access point. Before you use the utility, you must have an
active radio connection.
To use the MobileLAN access Utility
You must use the appropriate Intermec power supply with these
devices or equipment damage may occur.
Attention: Vous devez utiliser la source d'alimentation Intermec
adéquate avec cet appareil sinon vous risquez d'endommager
l'équipement.
1 Insert the MobileLAN access Tools CD into your PC's CD-ROM
drive. The CD starts automatically and you will see the CD home page.
Click Install the MobileLAN access Utility. If you do not see the
home page, from the Start menu, choose Run. In the Open field, type
, where X is the CD-ROM drive.
X:\INDEX.HTM
Or, use a web browser to navigate to http://www.intermec.com. From
the Service & Support menu, click Downloads. Choose Wireless:
MobileLAN access Utility to download the MobileLAN access Utility.
2 Follow the instructions that appear on your screen to install the utility.
3 Start the utility. The MobileLAN access Utility main screen appears.
MobileLAN access System Manual