Intermec MobileLAN access WA21 System Manual page 39

MobileLAN access System Manual
In the Root Priority field, enter 0.
b
In the Secondary LAN Bridge Priority field, enter a number other
c
than zero.
In the Secondary LAN Flooding field choose Enabled.
d
5 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 36.
6 Configure the master radio in the point-to-point bridge on the primary
LAN.
From the main menu, click the link corresponding to the master
a
radio. The radio screen appears.
In the Node Type field choose Master, and then click Submit
b
Changes.
7 Configure the spanning tree settings for the point-to-point bridge on
the primary LAN.
From the main menu, click Spanning Tree Settings. The Spanning
a
Tree Settings screen appears.
In the Root Priority field, enter a number other than 0.
b
In the Secondary LAN Bridge Priority field, enter 0.
c
In the Secondary LAN Flooding field choose Disabled.
d
8 If the roaming end devices will be roaming across an IP router, you
must configure IP tunnels. For help, see "Configuring IP Tunnels" in
Chapter 5.
9 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 36.
Chapter 1 — Getting Started
25