Intermec MobileLAN access WA21 System Manual page 143

MobileLAN access System Manual
2 For each frame subtype field, check or clear the check box to configure
if the frame subtypes are passed or are dropped. If you check the check
box, the frame subtype is allowed to pass.
3 In the SubType field and choose the customizable frame subtype. For
help, see the next table.
4 In the Value field enter the two hex pairs. For help, see the next table.
5 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 36.
Subtype Filter Descriptions
Subtype Value
DIX-IP-TCP-Port Port value in hexadecimal.
DIX-IP-UDP-Port Port value in hexadecimal.
DIX-IP-Protocol Protocol number in hexadecimal.
DIX-IPX-Socket Socket value in hexadecimal.
DIX-EtherType Specify the registered DIX type in hexadecimal.
SNAP-IP-TCP-Port Port value in hexadecimal.
SNAP-IP-UDP-Port Port value in hexadecimal.
SNAP-IP-Protocol Port value in hexadecimal.
SNAP-IPX-Socket Socket value in hexadecimal.
SNAP-EtherType SNAP type in hexadecimal. To filter on both SNAP type and
OUI, use advanced filters.
802.3-IPX-Socket Socket value in hexadecimal.
802.2-IPX-Socket Socket value in hexadecimal.
802.2-SAP 802.2 SAP in hexadecimal.
Chapter 5 — Configuring the Spanning Tree
129