Scanning In Single Mode; Cards With Unknown Hollerith Codes; Settings In The Control Window - Oce 3000 User Manual

Scanning in Single mode

The Océ 3000 Microfilm Scanner feeds, scans and displays one card and waits
for your command to print, file, reject or rescan the image. After the image has
been accepted, the card is ejected into the output hopper.
The image of each card is displayed on the run-time display window. The
machine pauses and you can inspect the image. You can now change the
scanning parameters and then rescan the card until you obtain a satisfactory
image. When you are satisfied with the displayed image, you can accept the
image and send it to the required output. If the output mode is set to print, file
or print/file, the system automatically produces the desired output. In the View
mode, no output is generated.

Cards with unknown Hollerith codes

In Single and Auto Feed mode, you can add a string of Hollerith data to cards
without Hollerith punches or with unknown Hollerith codes. The special
'Hollerith Add Mode' in the Configuration menu is designed for this purpose
(see 'Configuration' on page 85). When 'Hollerith Add Mode' is on, the
software generates a string of Hollerith data for a card. This string of data is
displayed on the Run-Time Display window, placed in the header of the image
data file and stored in the LOG file, if activated.

Settings in the Control window

Before activating the scanning process, you set the scanning control in the
Control window.
To start a scanning session in Single mode:
Click the Single button in the Running Mode entry box.
1
Select the Input Size or select Hollerith Sizing.
2
In Configuration of the Utilities pull down menu, set Hollerith Add Mode on
3
or off as required.
Select the desired Output Mode.
4
If the output mode is set to Print or Print/File, set the Print Control settings as
5
required.
Scanning 23