Oce 3000 User Manual page 79

To set the Océ 9400 as default printer:
Click the name of the printer in the list of installed printers.
1
Click Set As Default Printer.
2
The name of the selected printer appears in the Default Printer box in the top
of the Printer setup window.
Select the appropriate RCF file.
3
Click Connect.
4
The Connect window appears (see figure 61 on page 81).
Make sure when you connect a printer this printer is set as default.
Note:
The Connect window allows you to select the communication interface
between your printer and the controlling PC. You can connect the printers via
a network, a SCSI port or a Centronics parallel port. If you choose the network
connection, the Network entry box becomes available, where you enter the
path to the printing spool directory. If you choose a SCSI connection, the SCSI
entry box becomes available, where you set the SCSI address and the path to
the printing spool directory.
Select the required interface for your printer in the Port box.
5
If you have selected the Centronics option, proceed with step 8.
6
If you have selected the Network option, fill in the Network entry box.
7
If you have selected the SCSI option, fill in the SCSI entry box.Click OK.
8
You return to the Printer Setup window.
Click Setup.
9
The Setup window appears.
2112.tif
[59] Océ 9400 Setup window
Click the appropriate Roll boxes for roll 1 or roll 2.
10
Click OK.
11
Setting up the Océ 3000 Microfilm Scanner 79