Oce 3000 User Manual page 86

Load Cards: you can select how you want to load cards: face up or face
down (default). Depending on your printer configuration, one of these
options enables the printer to deliver printed copies in the same sequence as
the pack of cards: the card on top will be printed on top.
The Maximum Disk Usage: you can keep a part of the hard disk of the
controlling PC available for other tasks than scanning. Before scanning a
card, the system estimates the required space to generate the disk file. If this
space exceeds the defined percentage use, scanning and filing is paused until
there is enough space made free on the disk to contain the image file.
The counter: this counter can be reset to start from any number within the
range 0 to 9999999.
Proceed as follows to select the required start-up settings:
To set your own start-up settings:
Set the parameters as required in the following menus:
1
the Scanner Setup
the Printer Setup
File Handling
Job Management
Control Window
Click Utilities in the Control screen.
2
Click Configuration in the pull down menu.
3
Set the parameters in the Configuration menu.
4
Click Save New Defaults.
5
Click Update.
6
The next time the system is started, the new default setting will be used.
To set the factory default settings:
Click Utilities in the Control screen.
1
Click Configuration in the pull down menu.
2
Click Factory Settings.
3
Click Update.
4
The next time the system is started, the factory default settings will be used.
86 Océ 3000 User Manual