Operator Type - Genie GCL-GH Installation Manual

Operator Type Fig. 3
These operators are available for use in jackshaft or trolley configurations. The same
control board is used for either configuration, however the control board must be set
for the appropriate GDO configuration. A board set for trolley mode will not work in a
jackshaft operator and vice-versa.
NOTE: The GDO type is factory set. The installer should not have to set this
feature. However, if the GDO type is inadvertently changed, or if a board needs
to be replaced in the field, follow these instructions to set GDO type.
L
1) Press CAL/RUN CAL to enter calibration mode.
S
RUN
until display reads "GDO TYPE > ."
2) Press SCROLL
SCROLL
This will display the current GDO type.
3) Press SET/CLEAR SET until display indicates correct GDO type
CLEAR
( J-SHAFT or TROLLEY)
4) Press CAL/RUN CAL to return to run mode.
RUN
GCL-GH
Heavy Duty Operator
www.geniecompany.com
OPEN
GDO TYPE J-SHAFT
CLOSE
STOP
CAL SET
SCROLL
RUN CLEAR
SCROLL
Figure 3
03-12
7.2